Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300WM problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dieselboy427" data-source="post: 779559" data-attributes="member: 5768"><p>I am having some big issues with some FC brass. I bought it once fired from the classifieds on here. I tumbled, deprimed, chamfered, lubed and am trying to FL size before i trim. I'm using Redding dies and Hornady spray lube. I have ran probably 200 rounds through these dies and with the expander out, they look polished well inside. My loading area is about 70 degrees inside so lube temp isn't an issue i believe. The cases are sticking in the die and with VERY little effort, shears the case heads off. I removed the expander and tried again. FL 5 cases and the 6th stuck TIGHT but with the expander out, it drove right out. I put a brass brush through the die and some solvent and brake clean after the first couple problems. Apparently that didnt work either. This is getting expensive and i want it fixed on the FC brass so I don't ruin my RWS stuff. </p><p></p><p>Thanks in advance</p></blockquote><p></p>
[QUOTE="dieselboy427, post: 779559, member: 5768"] I am having some big issues with some FC brass. I bought it once fired from the classifieds on here. I tumbled, deprimed, chamfered, lubed and am trying to FL size before i trim. I'm using Redding dies and Hornady spray lube. I have ran probably 200 rounds through these dies and with the expander out, they look polished well inside. My loading area is about 70 degrees inside so lube temp isn't an issue i believe. The cases are sticking in the die and with VERY little effort, shears the case heads off. I removed the expander and tried again. FL 5 cases and the 6th stuck TIGHT but with the expander out, it drove right out. I put a brass brush through the die and some solvent and brake clean after the first couple problems. Apparently that didnt work either. This is getting expensive and i want it fixed on the FC brass so I don't ruin my RWS stuff. Thanks in advance [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300WM problems
Top