Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
30-06 resized to 25-06 getting "donuts"
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MikeMurf0505" data-source="post: 406549" data-attributes="member: 14538"><p>I am resizing some once fired factory 30-06 and 270 cases through my 25-06 full legnth sizing die and getting a small (for lack of a better word) donut below the neck, where it meets the top of the shoulder.</p><p> </p><p>I tried annealing some cases before sizing them, and it did not change the donut at all.</p><p> </p><p>Is this common when you resize 30-06 and 270 into 25-06?</p><p> </p><p>I am using the same FL die I used to make all my killer accurate 87 grain reloads.</p><p> </p><p>I am lubing the inside of the necks, and out side of the necks with RCBS case lube.</p><p> </p><p>I just tried a few of them in my gun and none of them seem to chamber, even when I try 2.490 and 2.492 lengths (shorter than max.).</p><p> </p><p>What am I doing wrong?</p><p>Why wont these chamber?</p><p> </p><p>Any ideas - besides just go get 25-06 cases and call it a day (which is what I am strongly considering right now.).</p></blockquote><p></p>
[QUOTE="MikeMurf0505, post: 406549, member: 14538"] I am resizing some once fired factory 30-06 and 270 cases through my 25-06 full legnth sizing die and getting a small (for lack of a better word) donut below the neck, where it meets the top of the shoulder. I tried annealing some cases before sizing them, and it did not change the donut at all. Is this common when you resize 30-06 and 270 into 25-06? I am using the same FL die I used to make all my killer accurate 87 grain reloads. I am lubing the inside of the necks, and out side of the necks with RCBS case lube. I just tried a few of them in my gun and none of them seem to chamber, even when I try 2.490 and 2.492 lengths (shorter than max.). What am I doing wrong? Why wont these chamber? Any ideas - besides just go get 25-06 cases and call it a day (which is what I am strongly considering right now.). [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
30-06 resized to 25-06 getting "donuts"
Top