spin-one
Well-Known Member
I have a 6.5 PRC that developed the dreaded clickers caused by too tight of SAANI tolerance. I have ordered a custom reamer to correct this issue so I am familiar with the problem. I have a semi custom 280ai built off a Winchester model 70. I purchased 100 pieces of Nosler brass because it was all that was available at the time. I fired all 100 at a mid range charge so as to form to my chamber. On the second firing during load development it started getting a slight bolt click. I am using 60.0gr of H4831sc so I am not running too hot of a load. It doesn't make a difference what charge load I use. I am not aware of the 280ai developing a bolt click issue. I have heard the Nosler brass is soft so I was wondering if this could be a factor in developing a slight bolt click?
Thanks
Scott
Thanks
Scott