25cal accubonds

Discussion in 'Reloading' started by yotkiller, Mar 20, 2006.

  1. yotkiller

    yotkiller Member

    Messages:
    6
    Joined:
    Mar 4, 2006
    I just purchased 15 110gr Accubonds from bulletdudes.com to work up a couple of test loads in my 25-06. Does any have a good load worked up? I am was think about trying H1000 and IMR4831
     
  2. KRob

    KRob Well-Known Member

    Messages:
    115
    Joined:
    Oct 5, 2004
    Ok this doesnt answer your question but if you go to Shooter Pro shop you can by factory secound from nosler for cheap.
     

  3. remingtonman_25_06

    remingtonman_25_06 Well-Known Member

    Messages:
    2,030
    Joined:
    Jun 4, 2003
    I loaded up a load with h4831 powder. 51g gives me .4" at 100 yards, and 3.5-4" at 500 yards. Rifle is a factory winchester 25-06. Average velocity is 3085fps.
     
  4. Hired Gun

    Hired Gun Well-Known Member

    Messages:
    1,537
    Joined:
    Apr 21, 2003
    I had terrible luck with them in my 25-06 and in my 257Wby. Out to 800 yards the 100 grain Partitions ruled. I couldn't get any respectable velocity out of them and they threw a lot of fliers that drove me crazy.
     
  5. johnnyk

    johnnyk Well-Known Member

    Messages:
    1,731
    Joined:
    Dec 24, 2001
    Yotkiller,
    I tried the 110gr AB in my .25-06 Sendero using 54.5gr of RL22 and Rem 9.5M primer. Accuracy ran .6965" and average velocity was 3271 fps. I did this same load on two different occassions and velocity average came out the same and accuracy was .669". This shooting was done about 3 days apart.
    I like the speed for this bullet but I personally want better accuracy. I'm sure I can't shoot or see the difference at 2/3/4 & 500yds but I know I'll never have the needed confidence to make the longer range pin point shots.
    Guess that means I get to try try again. JohnnyK.