Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
25-06 case head seperation?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Fitch" data-source="post: 367037" data-attributes="member: 19372"><p>My initial thought is that if doing that results in a case that is too short for safety, the die is defective. Why do I think that?</p><p> </p><p>I think that because one should be able to screw the FL sizing die down into full firm contact with the shell holder and end up with FL sized brass at the SAAMI spec. The instructions on every FL sizing die I ever owned says to do just that. So I am confused, how does screwing it down to less than contact result in too short a case? </p><p> </p><p>Thanks</p><p>Fitch</p></blockquote><p></p>
[QUOTE="Fitch, post: 367037, member: 19372"] My initial thought is that if doing that results in a case that is too short for safety, the die is defective. Why do I think that? I think that because one should be able to screw the FL sizing die down into full firm contact with the shell holder and end up with FL sized brass at the SAAMI spec. The instructions on every FL sizing die I ever owned says to do just that. So I am confused, how does screwing it down to less than contact result in too short a case? Thanks Fitch [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
25-06 case head seperation?
Top