200 gr accubond 300 win mag load needed

200 gr Nosler Accubond, 78 grains of H1000 set 30,000 off the lands, WLR primer, this combination prints a half inch group at 100 yards. I tried this load with a Fed 215M and it printed about an inch group at 100 yards. Speed is averaging 2,778 fps this is out of my Savage 16 Bear Hunter. That gun has a 23" barrel with 2 inches of that being a muzzle-brake....good luck!gun)
 
72.5 grs of R22, accuracy load out of Nosler manual, with CCI 250 gave me .75 " groups and 2900 ish fps in my 24" Rem 700 barrel. It's a max load;work up to it!!
 
72.5 grs of R22, accuracy load out of Nosler manual, with CCI 250 gave me .75 " groups and 2900 ish fps in my 24" Rem 700 barrel. It's a max load;work up to it!!

That's about the same load I started with in my old 300wm as well, although it was closer to 1/2" and I was using fed215m's.
 
Warning! This thread is more than 8 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top