Rflshootr's latest activity

My flattest shooting round is my 22-250AI. I have backed it down a little on velocity, but it was over 4200 with 40 grain pills.

6 mm Remington doesn’t suck. Take a look at it.

I’m not sure what’s practical about a 20 Practical. The 204 Ruger is already available in ammunition, reloading components and rifles...

A 300 WM to shoot hogs out of a helicopter? Really?:rolleyes: I kind of think you should have went with a Ma Deuce. 🤣 Each to their...

That's what I figured I'd have to do....Will test as suggested and post results. Thanks guys!

I agree. Load 5 with the original BTO measurement. You still may need to tweak it a few thousandths. Your seating die setting will...

I would run 5 of the same as you have been and review poi. If off then also load up 5 more making the overall appropriate adjust to...

A "prefit" will cost you around $750 + go gauges+ nut werch+ barrel vise + carving into your stock to get the barrel nut to fit. A brux...

My buddy and I did the digging. He wasn’t a woodworker, so I paid him for his time and kept it. I had help with loading 😃. I have many...

Mid to upper end loads with IMR 3031 work very well with bullets in the 125-150 grain range.

I run 16.5” barrels due to suppressors attached. Not sure of my velocity at the moment but 3031 has been great for me with the 130...

Take a look at hodgdon’s reloading data center. Because your barrel is pretty short for a .308, you may want to run a powder that’s...

If you are going to try to make you own Hollow Points you should start with a Lathe or Mill to get the hole concentric. If it is not...

jrock is speaking volumes in few words. Lately, I have found some what we used to call "FAT" bullets in various lots of hornady...

Looks to me it needs polishing, nothing more. It may have some hard to see burrs where the reamer steps down for the throat above the...