Recent content by mountain cur

has anyone found a good place to keep the crank on a 15i

changed scopes and now i cant get it to go low enough at 20 yards there is always something

what scope works best on this tac, haveing problems keeping the one that came with it sighted in, can you get by with a rifle scope without wipeing it out, need help fast deer season is almost here.

shooting dead on out to 60 yards then at 70 yards im 2 inches left and the farther out i go the farther left it goes. any ideas, i do have hha on.

if you removed the rear hand grip its the spring that holds the pin in on the safety, look for a small hole under the hand grip make sure the small pin is still in then put the spring in and reinstall hand grip.

will the three fletch arrow be as stable as the 4 fletch, if so how long and and what brand, have been useing 2 inch duravane on the compound dont remember what they call them but there made for broadheads kinda like blazers little lower profile, tired of the fletching comeing off.

still need some ideas why my tac wont hold poi, when you first install scope it hits 12 inches left 10 high, if you adjust scope to dead center it will shoot good for awhile then go off. sent back to pse they replaced rail put new scope on and its the same, went to the dealer and they pulled a...

have same problem, i think some of mine is some limb problems but most of it has to do with moving the scope to far to one side to get the poi where you want it, was told by hawk if you go to far you run out of adjustment and the cross hairs can float around, check your rail and see if its off...

mine is off 1/16 inch to the right, the bow is new been haveing problems from the start run out of adjustment which causes the scope not to hold the poi. ps has never been dropped.

first are there any other arrows that will work in the tac, second is the scope rail built into the receiver or can you just remove the rail, found that mine is setting 1/16 inch off which makes it where you cany set the scope. when it shoots it shoots good but if i cant get this figered out...

think i found the problem the scope rail is is not centered its 1/16 th inch off to one side, anybody had this problem

has anybody else had any problems with sighting in the optimizer. i went from shooting a silver dollar group at 70 yards to a 10 inch group have checked and tryed all i know, getting ready to through it in the trash bin any ideas

will increasing magnification raise or lower point of inpact

right now im shooting 20/30/40/50/60/ dead on with the scope power set at 3.5. my question is if i turn scope power up to 5 or 6 could i be able to start at 70 and go up, hopeing someone has tryed this i would but dont have the room. i can tell you that at 50 yards changing it from 3.25 to 3.5...

reading your forum about the nock and vein clearance got me to check mine. when drawing the bow i do have some contact but when fully cocked im centered with eighth inch clearence top and bottom, it looks like your setup is different than mine have they changed the 2011 or 2012 models there no...