Recent content by Morack

I have 2-8# kegs of N560 one sealed one with about 7#’s would like to trade for RE26 located southwest of twin cities.

Thanks for the replies. I was under the impression that you needed to bed past recoil lug 1-2” will be interesting to see if accuracy improves without going past!

Do you rebed action after rebarreling or just from lug forward 1 1/2” or so? Thanks

Any experience with 175 lr or 175 edlx with 1:8 ?

Hornady Lock & Load Prep Center for sale in excellent condition . Comes with 4 case holders # 1, h5,16,and 35. Asking $350 shipped conus.

It says 1:8 optimal twist on the box. Wish I would have known!

Thanks for all the help. I looked on the Brux website and didn’t find either. I will have to give both Brux and Berger a call.

I heard the same so I built it on that data. I’ve been racking my brain trying to figure out what is happening. This rifle has been a treat to develop loads for and for the ease of doing so. Maybe I should try backing down to 3000 or so.

Not sure on rifling but suspect traditional, it’s a Brux barrel. I’m running them at 3150

I have a brux 1:8 initially had zero problems out to 450yrds during load development, but was shooting 700yrds and had first round impact then nothing with other shots. Had a 20’x10’ cut bank behind target for sighting missed shots, but nothing. Had my buddy shot into cut bank and could easily...

I noticed the same. Thinking of trying accubond 175 lr’s , do you know what those guys tried? Thanks Marc

Hi Ryan, Have you had any trouble with Berger 195’s blowing up down range? I have a 26” 1 in 8 twist @3150 fps. Thanks Marc

SPF to Idaho Sawyer

Yes

SPF to ksshooter