Ok i got the directions for the gauge and can get the belt to push n flat it catching on the gauge the brass been reloaded 5-6 times. most of the other brass goes right in like they did after first firing. just wanted to know if brass go n bad .
hello all still learning lot bout reloading high power. i have a 7mm rm and when i drop them in my wilson case gage they stop at the belt. Is my brss bad when that happens. thanks/
Hello thanks for all the help. yes i trimmed them or checked them each time. i put my calipers on the case and it is a bit bigger towards the belt. Is it ok to shoot the rounds i loaded up to work up my load still. will it b consistante still. thanks
Sorry new to reloading it is a savage 7mm rm. the brass has been loaded bout 5 times just necked sized. i tried 1 piece after i found out they were tight and it tight also. Don't think i can push it back with muy neck die can i. thanks
i made some rounds up to the lenght of a bullet i shut n chamber. Then i loaded up some rounds and the action is tight at closing the action and real tight opening it. have to bang bolt to open it. do i need seat bullet farther. any help be appreciated thanks.
ok my dummy bullet that i made by shutting it in my chamber getting that length. is that in the lands. and do i nedd to seat the bullet a little more to start working on my powder charge or go from where it is. thanks for all the help
ok I got my dummy bullet do i seat it a little deep and start loading or start with it where it is. Also i plan on starting with powder charge work up to the best group then start seating the bullet from there
thanks for the help.
Hello all i just starting to reload for my 7mm rem mag. I made a dummy bullet by putting in and shutting my action on my gun. should i start there with my loading of lowest mount of powder the seat bullet .010 after that thanks.
using h1000
168 berger