Lonewolf74
Well-Known Member
- Joined
- May 12, 2016
- Messages
- 734
I'm looking to find out what is the guidelines or recommendations on the minimum amount of shoulder left on a barrel after threading it for a brake or suppressor?
For example if the finished diameter of the barrel is .830 and you thread it 3/4-24 there will be approx .04 shoulder left for the brake to seat against. Is this enough or should there be more and do you have any rule of thumb to follow?
Your help is appreciated guy's
Joshua
For example if the finished diameter of the barrel is .830 and you thread it 3/4-24 there will be approx .04 shoulder left for the brake to seat against. Is this enough or should there be more and do you have any rule of thumb to follow?
Your help is appreciated guy's
Joshua