6.5 SHERMAN MAX

[lejuch]

hmmmmm. maybe 62 RL26 and 57 RL16

Thx

 

[highdrum]

Bushing size for 6.5 Max? .290?

per Highdrum:
Brass required turning for proper clearance. Process is: cleaned, annealed, sized w/ 287 bushing, expanded with 262 mandrel tumbled. Gives 2.5k nk tension.

Is this process for the New headstamped brass?
Maybe I'll get a couple different bshng.

I necked all my brass down with a 302 bushing, then 289, expanded with 263 mandrel, neck turned to 0.014 thickness as my rifle is chambered with the original max reamer that had a 296 nk, the newer revision has a 298 neck for no turn. I just can't vibe with Cases that don't slip a bullet in the neck after firing.

 

[elkaholic]

I necked all my brass down with a 302 bushing, then 289, expanded with 263 mandrel, neck turned to 0.014 thickness as my rifle is chambered with the original max reamer that had a 296 nk, the newer revision has a 298 neck for no turn. I just can't vibe with Cases that don't slip a bullet in the neck after firing.

The new formed brass has a thinner neck wall than the original brass

 

[highdrum]

The new formed brass has a thinner neck wall than the original brass

So now the 296 chamber is a no turn with the new brass? I got 100pcs from your last shipment I haven't inspected the dimensions yet, that's good to know!

 

[elkaholic]

So now the 296 chamber is a no turn with the new brass? I got 100pcs from your last shipment I haven't inspected the dimensions yet, that's good to know!

yes, you should have .004-005" clearance

 

[HuntnPack]

Rich, should I check with HCA & see which Reamer they have before I order bushing?
I was gonna get brass prepped & ready.

 

[elkaholic]

Rich, should I check with HCA & see which Reamer they have before I order bushing?
I was gonna get brass prepped & ready.

If you have the new brass, you should be fine.maybe get a .290" and a .292"

 

[highdrum]

Rich, should I check with HCA & see which Reamer they have before I order bushing?
I was gonna get brass prepped & ready.

Mike has the rev1 reamer. He chambered 2 rifles and one forming barrel for a friend and I.

 

[HuntnPack]

Guess I'll measure up & size some brass & see which reamer to go with accordingly. Need to find the best combo of Reamer neck dimension, neck bushing size, for neck tension
& clearance for bullet release, for the
New Brass as well as the Next Gen Brass.

 

[elkaholic]

Guess I'll measure up & size some brass & see which reamer to go with accordingly. Need to find the best combo of Reamer neck dimension, neck bushing size, for neck tension
& clearance for bullet release, for the
New Brass as well as the Next Gen Brass.

Id go with the Gen I and new hrass. it leaves a little room to turn if you want.
Next run of brass MAY be a little thicker?

 

[HuntnPack]

Thx. Rich, I'll go that route.

 

[Lenwood901]

any updates on this round good ballistics with the 156 bergers

 

[highdrum]

156 eol, 65.2 N570 w/ CCI 250 primers running 3150 from a 26" bartlein barrel.

 

[Lenwood901]

did you happen to try h 1000 too