Winchester m-70 firing pin design

diderr

Well-Known Member
Joined
Dec 16, 2007
Messages
566
Location
Gillette, WY
I have a pre-64 design FN, and want to put a Tubb firing pin in it. I looked on Midway and it says for post-64. And looking on the Tubb website it doesn't say pre or post. Are the firing pin designs identical?
Thank you.
 
I just had one installed on a Pre-64 Model 70 with the cocking piece, and it required a bit of fitting. I'm not sure how much as I had it done, but it works very well. As far as I know it's not going to drop in either way. Short and long were the choices I saw as well.
 
I kept thinking I saw it someplace, I went to the Tubb site and under the cocking piece it says the firing pin fits ALL (their caps) model 70's. The cocking piece for pre-64's requires the Tubb firing pin at the same time.
 
Warning! This thread is more than 12 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top