Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Who makes good brass for the 7mm rem mag?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="188MULE" data-source="post: 354689" data-attributes="member: 22670"><p>Thanks for the info and help, I think I've found the start of my problem.</p><p>The first run of brass ran right around .309, but I only measured a few to order my bushings. They all seemed to have about the same tension when seating the bullets.</p><p>I had just purchased a .305 to try to tighten the necks on the cases that felt loose but haven't tried this yet. This week I started loading with a different run of brass, still winchester, the bullets seated hard. The outside of the necks on a loaded round were around .310. After seeing the differences I measure the necks by spinning them in my mic and these case necks are not very consistant. So my next step is to get the equipment to turn the necks and measure them properly, or try out some norma brass.</p><p> </p><p>Thanks for the help</p></blockquote><p></p>
[QUOTE="188MULE, post: 354689, member: 22670"] Thanks for the info and help, I think I've found the start of my problem. The first run of brass ran right around .309, but I only measured a few to order my bushings. They all seemed to have about the same tension when seating the bullets. I had just purchased a .305 to try to tighten the necks on the cases that felt loose but haven't tried this yet. This week I started loading with a different run of brass, still winchester, the bullets seated hard. The outside of the necks on a loaded round were around .310. After seeing the differences I measure the necks by spinning them in my mic and these case necks are not very consistant. So my next step is to get the equipment to turn the necks and measure them properly, or try out some norma brass. Thanks for the help [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Who makes good brass for the 7mm rem mag?
Top