What height scopes rings? X-Bolt

Brydawg512

Well-Known Member
Joined
Nov 16, 2018
Messages
442
Location
Idaho
Hello,

About to purchase Browning X-Bolt in 7mm rem mag. I have a Vortex Viper PST 4-16X50 I am installing. I am going to install a EGW 20moa base. I am looking at the Seekins Precision 30mm rings... my question is what height will i need?
Thank you.
 
I use Burris xtr lows on mine with a 20 moa rail .I did have to cut the front of the rail off to get the scope to slide back where I wanted It though.
 
Yup, pretty much with any rail-type scenario, I use low rings (except AR platforms). I pretty much stick with low whenever I can if I have the bolt/bell clearance. The closer the reticle is to the axis of the bore the better IMHO.
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top