Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
What epoxy to use on recoil pad and HS stock
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="NesikaChad" data-source="post: 361389" data-attributes="member: 7449"><p>Well, that's a good question. Short answer, probably not very well. I don't use H/S stocks so forgive my earlier ignorance/answer.</p><p></p><p>CA (superglue) usually doesn't lend itself well to foam. There is foam safe stuff but it's not very good-especially for something like this.</p><p></p><p>I'd probably go with an epoxy. Something thin so that it'll wick into the foam's pores. Paint a layer on the foam, allow it to cure, then sand/machine it flat again, and then glue your pad to it. This way you have a hard/similar surface for the resin to bond to.</p><p></p><p>Good luck.</p><p></p><p>C</p></blockquote><p></p>
[QUOTE="NesikaChad, post: 361389, member: 7449"] Well, that's a good question. Short answer, probably not very well. I don't use H/S stocks so forgive my earlier ignorance/answer. CA (superglue) usually doesn't lend itself well to foam. There is foam safe stuff but it's not very good-especially for something like this. I'd probably go with an epoxy. Something thin so that it'll wick into the foam's pores. Paint a layer on the foam, allow it to cure, then sand/machine it flat again, and then glue your pad to it. This way you have a hard/similar surface for the resin to bond to. Good luck. C [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
What epoxy to use on recoil pad and HS stock
Top