sigsupermatch
Well-Known Member
- Joined
- Jan 11, 2012
- Messages
- 127
Can someone offer any information as to why this case and some others like it are hard to chamber. The brass history is as follows: the first re-size was full length. Next 2 re-sizings were neck only, Fourth re-size was full length and they were annealed.
The case shows no signs of pressure issues. Case walls are not bulging, not showing the tell-tell stretch ring (picture link at bottom.) The case's sticking point is just the very edge of the belt facing the mouth of the case. Wondering if a belted magnum collet die might correct the issue.
Side note: When I did the last FL size I put shims between the Case holder and case head to get as much of the case in the die as possible. I have close to 300 cases and the trouble ones total about 15.
https://web.mail.comcast.net/service/home/~/?auth=co&loc=en_US&id=261680&part=1
The case shows no signs of pressure issues. Case walls are not bulging, not showing the tell-tell stretch ring (picture link at bottom.) The case's sticking point is just the very edge of the belt facing the mouth of the case. Wondering if a belted magnum collet die might correct the issue.
Side note: When I did the last FL size I put shims between the Case holder and case head to get as much of the case in the die as possible. I have close to 300 cases and the trouble ones total about 15.
https://web.mail.comcast.net/service/home/~/?auth=co&loc=en_US&id=261680&part=1
Last edited: