Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Tempilaq temperature rating?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="squirrel chaser" data-source="post: 1059913" data-attributes="member: 78845"><p>I will appologize in advance if I am intruding on this thread but, found it intresting and when the U tube vidios were brought up I couldn't help myself. I watched one of these vidios and very carefully tried it with some .25 WSSM cases then went ahead and reloaded them as normal with the load my gun likes the best. The result was a case stuck in the chamber completely poping the primer out and making it very difficult to open the bolt. I thought I had made a mistake with the load somewhere so rechecked everything dropped the powder back to minimum just to be on the safe side and reluctantly tried it again with not quite as bad but yet the same results. Then tried a case I never annealed and loaded it with the same loads and it worked perfectly. Can anyone help me understand why this is happening?</p><p> Again sorry for jumping in on the thread,but new to the sight.</p></blockquote><p></p>
[QUOTE="squirrel chaser, post: 1059913, member: 78845"] I will appologize in advance if I am intruding on this thread but, found it intresting and when the U tube vidios were brought up I couldn't help myself. I watched one of these vidios and very carefully tried it with some .25 WSSM cases then went ahead and reloaded them as normal with the load my gun likes the best. The result was a case stuck in the chamber completely poping the primer out and making it very difficult to open the bolt. I thought I had made a mistake with the load somewhere so rechecked everything dropped the powder back to minimum just to be on the safe side and reluctantly tried it again with not quite as bad but yet the same results. Then tried a case I never annealed and loaded it with the same loads and it worked perfectly. Can anyone help me understand why this is happening? Again sorry for jumping in on the thread,but new to the sight. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Tempilaq temperature rating?
Top