Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Temperature Sensitivity of Alliant Reloder 26
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="codyadams" data-source="post: 1938615" data-attributes="member: 87243"><p>I would honestly be suprised if that wasn't a factor in some aspect. I have also wondered if specific cases could cause it to act differently. For instance, in my .260AI, it is a very high load density, and about perfectly balanced with burn rate, energy, and case fill, especially with the 156 Berger. However, when I tried it in my .338 Norma Mag with 265 ABLR's, case fill was very low in comparison. I would be willing to bet that I would get different results from it then I did my .260AI. </p><p></p><p>Bottom line in my opinion at this point, it is best to test it out yourself in your specific gun under the conditions you plan to use it in, with all powders. I don't really get the hot, 85°+ temps out here, especially during any hunting seasons, so it is a non issue for me, and I personally haven't seen the problem, but fully believe the people that have, it just doesn't apply to my circumstance. If I lived in New Mexico, I very well may be using a different powder.</p></blockquote><p></p>
[QUOTE="codyadams, post: 1938615, member: 87243"] I would honestly be suprised if that wasn't a factor in some aspect. I have also wondered if specific cases could cause it to act differently. For instance, in my .260AI, it is a very high load density, and about perfectly balanced with burn rate, energy, and case fill, especially with the 156 Berger. However, when I tried it in my .338 Norma Mag with 265 ABLR's, case fill was very low in comparison. I would be willing to bet that I would get different results from it then I did my .260AI. Bottom line in my opinion at this point, it is best to test it out yourself in your specific gun under the conditions you plan to use it in, with all powders. I don't really get the hot, 85°+ temps out here, especially during any hunting seasons, so it is a non issue for me, and I personally haven't seen the problem, but fully believe the people that have, it just doesn't apply to my circumstance. If I lived in New Mexico, I very well may be using a different powder. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Temperature Sensitivity of Alliant Reloder 26
Top