Stuck Case in Chamber

DirtNap35

Well-Known Member
Joined
Jul 29, 2021
Messages
152
Location
Kansas City
Went to range this morning and on the 7th round I had to force the bolt close a little. Well after firing I had a hard bolt lift, to were I had to yank on bolt to open. When I got the bolt opened I noticed my case was stuck in chamber. Got home and took cleaning rod and was able to gentle tap case out. After inspecting looks like my bolt face is damaged. The part missing is that the extractor? This is a terminus Kratos lite action.
90E562B7-6F1C-4185-A847-612A38D71E40.jpeg
 
That extractor looks like it just went By By. Did the casing show an Ejector flow imprint, If no flow into ejector hole, The extractor must just have broke, With no pressure problem to make it break.
 
That extractor looks like it just went By By. Did the casing show an Ejector flow imprint, If no flow into ejector hole, The extractor must just have broke, With no pressure problem to make it break.
I definitely have pressure with the load but never concerned me. I've fired 300 rounds with this load and for some reason this one spiked on me and I had to yank on bolt to open it. Guessing this caused the extractor to break.
 
You a real pressure problem when there is that much brass on the bolt face.
Yeah I know I'm into pressure but I've ran this load for over 300 rounds and never had any issues that concerned me. But yes after this I will back it down a little. This load shot so good which was why I was ok with the pressure I was seeing.
 
Last edited:
Top