Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Sheldon ks990 lathe?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="isaaccarlson" data-source="post: 2359779" data-attributes="member: 33850"><p>Here are some pictures. The picture of the tooling on the table is what it comes with and then there are close up pictures of the items. The change gears look like they have never been installed. He made the new large pulley with the green belt on it and replaced the leather belt with rubber. The original motor is a bit rough, so I may replace it with a treadmill motor for variable speed like I did on my drill press.</p><p></p><p>The guy said he is an engineer/machinist for work and he has a machine shop in his garage. He started on this lathe and now has a bigger one. He put this "kit" together to help someone get started. There are 10 quick change tool holders, a few were sitting on the lathe. I was hesitant to drive almost 2 hours to look at it, but I am glad I did. I'm pretty sure it will fit in the back of the rav.</p></blockquote><p></p>
[QUOTE="isaaccarlson, post: 2359779, member: 33850"] Here are some pictures. The picture of the tooling on the table is what it comes with and then there are close up pictures of the items. The change gears look like they have never been installed. He made the new large pulley with the green belt on it and replaced the leather belt with rubber. The original motor is a bit rough, so I may replace it with a treadmill motor for variable speed like I did on my drill press. The guy said he is an engineer/machinist for work and he has a machine shop in his garage. He started on this lathe and now has a bigger one. He put this "kit" together to help someone get started. There are 10 quick change tool holders, a few were sitting on the lathe. I was hesitant to drive almost 2 hours to look at it, but I am glad I did. I'm pretty sure it will fit in the back of the rav. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Sheldon ks990 lathe?
Top