Thunder Hunter
Active Member
I purchased .338 Lapua in 1993 with a I in 12 twist barrel. After another member talking to me about his gun, I decided to take a good look at my receiver to barrel fit. On first look I seen a 1/8 wear line down the bottom of the receiver. I proceeded to grease blue the bottom half moon of the receiver to see if I had full contact into the stock. This was the worst stock to receiver fit I've seen. The reverse bedding recoil lug was not even close to the receiver. If this had been a wood stock it would have split long ago. 17 hrs. later of scraping and sanding (No Power Tools) as the Pros do I finally have a mated surfaces. I wonder how many of you other Sako Lapua owners have spotted this?. The composit stock has to much shrinkage from the original mold to allow a perfect fit.