MagMan
Well-Known Member
On average how much extractor should be showing when you measure the diameter of the bolt face then measure to the extractor. More than .017"??
I'm having a problem with a 300 RUM not extracting about 5% of the time. I've measured the cases and have not seen any noticeable difference from ones that eject and ones that don't.
Bolt face = .542"
To the extractor = .525"
Any help would be greatly appreciated.
I'm having a problem with a 300 RUM not extracting about 5% of the time. I've measured the cases and have not seen any noticeable difference from ones that eject and ones that don't.
Bolt face = .542"
To the extractor = .525"
Any help would be greatly appreciated.
