Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
7mm STW
Rem 7STW brass question?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MagnumManiac" data-source="post: 2319277" data-attributes="member: 10755"><p>G'day all,</p><p>I just opened my other bag of Remington 7STW 100 count and went to prime them all on my Primal Rights CPS unit and found that the primers (WLRM) will not bottom out.</p><p>So I grabbed my RCBS Universal hand primer and proceeded to start priming the cases….my hand got sore almost immediately. Anyway, after seating a few, I grabbed my depth mic and started measuring. I almost fell over, my first reading was .008", then .0095" and finally .012". I then grabbed the rounds I had already loaded, measuring them from the other bag, was about the same, .008"-.010" below flush.</p><p>I have never seen this on any brass before, normally I have shallow pockets that need addressing, not pockets that are too deep.</p><p>So, has anyone else seen this?</p><p>I have a feeling the pockets may open early.</p><p>What say you all?</p><p></p><p>Cheers.</p></blockquote><p></p>
[QUOTE="MagnumManiac, post: 2319277, member: 10755"] G’day all, I just opened my other bag of Remington 7STW 100 count and went to prime them all on my Primal Rights CPS unit and found that the primers (WLRM) will not bottom out. So I grabbed my RCBS Universal hand primer and proceeded to start priming the cases….my hand got sore almost immediately. Anyway, after seating a few, I grabbed my depth mic and started measuring. I almost fell over, my first reading was .008”, then .0095” and finally .012”. I then grabbed the rounds I had already loaded, measuring them from the other bag, was about the same, .008”-.010” below flush. I have never seen this on any brass before, normally I have shallow pockets that need addressing, not pockets that are too deep. So, has anyone else seen this? I have a feeling the pockets may open early. What say you all? Cheers. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
7mm STW
Rem 7STW brass question?
Top