Rem 700 VTR Feed Problems

sabotagefront

Member
Joined
Jun 21, 2010
Messages
7
So I worked up my first load for my new Remington VTR in .243 today and took it to the range, it shot great except for the fact that it would not feed effectively. The rounds were difficult to push in to the magazine and when I operated the bolt only the surface of the brass was scrapped. I was using nosler 95gr ballistic tips and the C.O.L was 2.71, and there was plenty of room in the magazine. I took it home and played around with it for a while with no success. Any ideas?
 
Warning! This thread is more than 14 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top