Redding type s bushing dies VS FL Resizing dies

Cruizin

Well-Known Member
Joined
Dec 25, 2006
Messages
308
So I am building a 6.5 x 284 that is chambered specifically for lapua brass. I am trying to decide what dies to go with. I have a few redding type s bushing neck and body dies and I seem to like them but I have noticed after a few loadings that the brass at the bottom of the neck seems to increase in thickness.
I don't quite know what to think about this or how to feel about it. Has anybody else experienced this and have you found it to cause issues with ES?

What dies would you go with on this build?

Thanks for your feedback,

Cruizin.
 
Warning! This thread is more than 14 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top