Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recoil Pad Help!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="David Emerson" data-source="post: 2023887" data-attributes="member: 112579"><p>I have a 12 inch carbide blade miter saw. Get it lined up right and off it comes leaving a perfect surface. I wrap the butt in tape just in case to keep from any chipping but never a problem. Screw the new pad on and scribe it and then grind to size on a belt sander. If screws are not an option use epoxy. To add. I set the saw with a 3 degree angle to make the toe undercut the top. The stock will fit better and stay on your shoulder better.</p></blockquote><p></p>
[QUOTE="David Emerson, post: 2023887, member: 112579"] I have a 12 inch carbide blade miter saw. Get it lined up right and off it comes leaving a perfect surface. I wrap the butt in tape just in case to keep from any chipping but never a problem. Screw the new pad on and scribe it and then grind to size on a belt sander. If screws are not an option use epoxy. To add. I set the saw with a 3 degree angle to make the toe undercut the top. The stock will fit better and stay on your shoulder better. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recoil Pad Help!!!
Top