Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recoil lug question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Jeffrthehunter" data-source="post: 2056821" data-attributes="member: 98990"><p>Thanks for the input! Basically I want go with .002" clearance between tenon recoil lug journal (1.073") and lug through hole (comes pre bored at 1.075"). This way if there is some radial alignment error after pining recoil lug I will still have clearance. I feel like the worst senerio would be to have the lug pushing the barrel to to one side of receiver. Hope I am explaining this correctly.</p></blockquote><p></p>
[QUOTE="Jeffrthehunter, post: 2056821, member: 98990"] Thanks for the input! Basically I want go with .002" clearance between tenon recoil lug journal (1.073") and lug through hole (comes pre bored at 1.075"). This way if there is some radial alignment error after pining recoil lug I will still have clearance. I feel like the worst senerio would be to have the lug pushing the barrel to to one side of receiver. Hope I am explaining this correctly. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recoil lug question
Top