rechamber

old fart

Well-Known Member
Joined
Dec 8, 2003
Messages
125
Location
Aurora , Colorado
gents - take a stock heavy barreled 260 rem ,can it be rechambered to a 6.5/284, would it be practical ,would it be better . maybe a new stock , add a break , thanks
 
I belive that it could be recambered to 6.5-284. For me it wouldnt be practical as I think I would get more barrel life out of the 260. The other would be faster though. I also am not sure what your goals are either. It would help to know more about your rifle and also more about what you want out of the rifle.
 
Ahhhh... most of the 'good' bullets in 6.5mm are pretty close to 140gr, plus or minus a very small amount: 139gr Lapua, 141gr Cauterrucio VLD, 140gr JLK VLD, 142gr SMK. The longer stuff like 155gr+ aren't good for much as far as long range is concerned.

As far as 6.5-08 vs 6.5-284 in a factory gun, I guess the thought in my mind is are you going to actually realize enough velocity difference in that length of barrel? The 6.5-284 generally does a little better w/ more room to stretch it's legs, so to speak.

HTH,

Monte
 
gents - I ran across a remington long action , with a long magazine , in a pawn shop. the barrel has been replaced , med weight, about 26", triggers been replaced , the bore is real bad, full of copper , the throat is worn , but the thing looks like it might clean up - the wood is stock no damage , but looks like they had a bi -pod.
the new barrel doesn't bind in the stock and looks good - even - and can slide a dollar to the action . the barrel is marked 260 REM - 9 , hand stamped- thought it might clean up with a 6.5/284 with out loosing length. find a replacement follower for inside the mag and I would have something to practice with , besides my 308's and another mid range rodent to deer gun with low recoil - thanks
 
If it's a long action, then I woud say go for it. Using a reamer throated for the longer, not heavier, 142 MK, or the VLDs would give you an advantage over the 260 in any length barrel.
 
Chris - Its a long action - who ever did this has soldered a piece of metal on the follower - I guess to keep things, cases , from moving around . thanks
 
Warning! This thread is more than 21 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top