Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Process for necking down from 30 caliber to 7mm?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dok7mm" data-source="post: 1477371" data-attributes="member: 90080"><p>I neck down Nosler 8mm brass to form all my 7stw brass. To turn the brass, you need to check the neck I.D. to be sure it's smaller than your turning expander. Also, be mindful to set the die so you don't bump the shoulder back too far, just enough to size all the neck. I prefer the FL Forester die with the stem removed, but with their expander ball location, you can lube inside the neck and use the stem installed. Very little runout involved. Once you get your die set up, the rest is very simple.</p></blockquote><p></p>
[QUOTE="dok7mm, post: 1477371, member: 90080"] I neck down Nosler 8mm brass to form all my 7stw brass. To turn the brass, you need to check the neck I.D. to be sure it's smaller than your turning expander. Also, be mindful to set the die so you don't bump the shoulder back too far, just enough to size all the neck. I prefer the FL Forester die with the stem removed, but with their expander ball location, you can lube inside the neck and use the stem installed. Very little runout involved. Once you get your die set up, the rest is very simple. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Process for necking down from 30 caliber to 7mm?
Top