Primer Pocket Uniformity/Cleaning Tool

SES50

Well-Known Member
Joined
Feb 26, 2007
Messages
269
Location
San Jose, Ca
I am looking to clean up my primer pockets but since I am starting to do this I figure I might as well square it up and debur it. Can anyone suggest the tools I should buy?

Primer Pocket Squaring Tool?
Flame Hole Uniformer?
Flame Hole Deburing?

Please help, there are so many out there it is hard to just pick one. /ubbthreads/images/graemlins/confused.gif

Thanks
 
I use the K&M's - the primer pocket tool fits in a power screwdriver "as is". Not that I've tried others, or am as experienced as most here, I've been happy with the results.
 
I use an RCBS and it works fine. It has an adjustment set screw, DON"T ADJUST IT. it is set at SAAM specs from factory. I use it on a RCBS power station.
 
Warning! This thread is more than 17 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top