Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Possible issue with Redding Type S bushing die
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cornchuck" data-source="post: 1427086" data-attributes="member: 20220"><p>Thank you all for the replies. </p><p></p><p>243winxb- That was a helpful and informative piece from Redding.</p><p></p><p>cdherman- The ones I have measured are all right there at .308. </p><p></p><p>cdherman and DUSTY NOOGIN- When I developed this load, I was seating them at 2.227" CBTO. I did a seating test recently where I ran the bullet out to 2.3" in 0.010 increments starting at 2.227. I found one load that shot good at 2.290" and stuck with it. Never paid attention to a bulge. When I was seating deeper there was probably no bulge. And no I didn't run it to 2.290" because of barrel erosion. I don't think I'm there yet.</p><p></p><p>Looks like I'll seat them deeper.</p><p></p><p>Thank you again</p><p>Jason</p></blockquote><p></p>
[QUOTE="cornchuck, post: 1427086, member: 20220"] Thank you all for the replies. 243winxb- That was a helpful and informative piece from Redding. cdherman- The ones I have measured are all right there at .308. cdherman and DUSTY NOOGIN- When I developed this load, I was seating them at 2.227" CBTO. I did a seating test recently where I ran the bullet out to 2.3" in 0.010 increments starting at 2.227. I found one load that shot good at 2.290" and stuck with it. Never paid attention to a bulge. When I was seating deeper there was probably no bulge. And no I didn't run it to 2.290" because of barrel erosion. I don't think I'm there yet. Looks like I'll seat them deeper. Thank you again Jason [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Possible issue with Redding Type S bushing die
Top