Anders Bruun
Member
I think that i already have found my problem, but not shure how to solve it.
I use Redding Comp dies - neckseizer with bushings - no expander.
In my 6.5 x 55 it is perfect - no problems
But in my 308 i get a bullet runout about .005" - the fired case is fine, but after neckseizing, it in no good
I think the problem is, that i have to set the neck back .008"
Here goes the question (finally) - if i set the neck back in 2 x .004 - will that give me a perfect result - or is it just half a solusion ?
If it is no - good, how can i get my .001" runout, with that kind of set-back ?
Thank you for helping !
Regards
Anders Bruun
I use Redding Comp dies - neckseizer with bushings - no expander.
In my 6.5 x 55 it is perfect - no problems
But in my 308 i get a bullet runout about .005" - the fired case is fine, but after neckseizing, it in no good
I think the problem is, that i have to set the neck back .008"
Here goes the question (finally) - if i set the neck back in 2 x .004 - will that give me a perfect result - or is it just half a solusion ?
If it is no - good, how can i get my .001" runout, with that kind of set-back ?
Thank you for helping !
Regards
Anders Bruun