New barrel blocks


Well-Known Member
Oct 14, 2004
Atlanta, GA
A bit ago I jumped the gun announcing a new vented barrel block through PT&G. Dave lateraled the project off to Chris at Long Shot Rifles, [email protected], who just announced today that the first batch are in production including my request for a vented block for the large powder burners. Shawn, if you read this, this is ( was???) the delay point for the Edge.

Since I use a block now on a magnum, I can verify that for the home smith, a block is dead easy to bed and install as the block is actually bonded to the stock then the barreled action is locked into the block. Overbore
Warning! This thread is more than 17 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.