Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Neck Turning Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tourguide" data-source="post: 21244" data-attributes="member: 245"><p>I have a 8mm REM mag case, and I'm try to figure out the minimum case wall thickness when turning it down. What do you think the minimum thickness can be before something bad happens????? </p><p></p><p>Do you think the best method of neck turning is outside or inside? It's a 8mm necked down to 30cal. So the case gets resized, I have been turning only fireformed brass after resizing.</p><p></p><p>How much variance of wall thinkness do you think you should see?</p><p></p><p>Thanks for the help.</p></blockquote><p></p>
[QUOTE="tourguide, post: 21244, member: 245"] I have a 8mm REM mag case, and I'm try to figure out the minimum case wall thickness when turning it down. What do you think the minimum thickness can be before something bad happens????? Do you think the best method of neck turning is outside or inside? It's a 8mm necked down to 30cal. So the case gets resized, I have been turning only fireformed brass after resizing. How much variance of wall thinkness do you think you should see? Thanks for the help. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Neck Turning Question
Top