• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Neck tension or case neck thickness?

earl1704

Well-Known Member
Joined
Aug 7, 2007
Messages
52
Location
Northern California
Seating 7mm Berger bullets.
Nosler brass.
Hornady Custom Grade Full Length die, Series 1.

Question is as I seat the bullet on some cases the bullet seems to drag as it goes into the neck. Most go in smoothly but every 6 or 7th case they become hard to seat.

I assume this will affect velocity, so is this a neck tension problem with the expander ball or die set?

I brush each neck at least 3 times during case prep. I check for small burrs bent case necks and anything else I can see that may be in the way as the bullet seats. I have checked the bullets for concentricity which are perfect.

I don't neck turn but I assume the expander ball makes the inside of each case neck the same size, so why why would some bullets seat smoothly and others not?

Earl
 
Warning! This thread is more than 8 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top