Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck Sizing Vs. Full Length Sizing and Neck Tension
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="brant89" data-source="post: 2219466" data-attributes="member: 49553"><p>I would also add that it usually takes two or three firing for a case to stretch to full chamber length. I know this because I run zero headspace on my brass and always find a little more spring-back in the brass in the first couple firings. I only point this out because if you set your FL die on the first firing and never adjust it after that, you might have more than your targeted .002" headspace.</p></blockquote><p></p>
[QUOTE="brant89, post: 2219466, member: 49553"] I would also add that it usually takes two or three firing for a case to stretch to full chamber length. I know this because I run zero headspace on my brass and always find a little more spring-back in the brass in the first couple firings. I only point this out because if you set your FL die on the first firing and never adjust it after that, you might have more than your targeted .002" headspace. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck Sizing Vs. Full Length Sizing and Neck Tension
Top