neck sizer

dave1

Well-Known Member
Joined
Jul 6, 2008
Messages
229
Location
pa
I am shooting a 7 rum . I have RCBS FL die set. I am wondering if I should buy a neck size die?
Questions / comments are appricated.
 
Shim the FL die up with a nickel on both sides and you are neck sizing. They are nice to have though, no lube needed usually.
 
They're sure nice to have. I use my neck sizers a lot.
I'm getting only 4 neck sized reloads out of my 270 WSM before they won't fit in the chamber. Then I must use the Full Length sizer.

My 7mm RM has 5 reloads on most of the brass and haven't needed FL sizer yet.
Go Figure. :D





JM .02
 
well I think I will get one. ever heard of the brass being tight clear up at the end the body. ( right below primer on the body) it fits in the chamber just a lil tight?
 
well I think I will get one. ever heard of the brass being tight clear up at the end the body. ( right below primer on the body) it fits in the chamber just a lil tight?

Yep, that is why FL sizing is required! NS will never fix that.

Save you $ and learn to properly adjust the FL die to give .002 shoulder push back and no need to NS die.


BH
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top