Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Measure Bullet Seating?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mikecr" data-source="post: 346739" data-attributes="member: 1521"><p>+1 on the COL E-Z Check rod. It works good.</p><p></p><p>Now this is OAL(to bullet tip), and after getting the measurement with the rod, I seat that same bullet until it matches the OAL measured(into lands). Then I put a Sinclair nut on it and log OGV JAM.</p><p>All adjustments from there are based on the OAL to OGV as measured using the nut/calipers.</p></blockquote><p></p>
[QUOTE="Mikecr, post: 346739, member: 1521"] +1 on the COL E-Z Check rod. It works good. Now this is OAL(to bullet tip), and after getting the measurement with the rod, I seat that same bullet until it matches the OAL measured(into lands). Then I put a Sinclair nut on it and log OGV JAM. All adjustments from there are based on the OAL to OGV as measured using the nut/calipers. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Measure Bullet Seating?
Top