Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Houston I have a problem (22-250)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="blackbrush" data-source="post: 366880" data-attributes="member: 11280"><p>When doing load work I normally clean up the cases completely then before I move from my press, I will set each unfired/unprimed case in the action and close the bolt. If it is difficult or impossible as you mention, I will take it out and use a bump die from Redding and set the shoulder down about .001". </p><p></p><p>Take it out and try to rechamber. You should be good to go.</p><p></p><p>Once your load development has calmed and you have sized that brass this normally doesn't happen again unless something gets out of sorts, e.g., down in South Texas and leaving your rifle and ammo in the truck. It gets VERY hot and can respond somewhat different.</p><p></p><p>Again this is assuming you have weighed and culled your brass.</p></blockquote><p></p>
[QUOTE="blackbrush, post: 366880, member: 11280"] When doing load work I normally clean up the cases completely then before I move from my press, I will set each unfired/unprimed case in the action and close the bolt. If it is difficult or impossible as you mention, I will take it out and use a bump die from Redding and set the shoulder down about .001". Take it out and try to rechamber. You should be good to go. Once your load development has calmed and you have sized that brass this normally doesn't happen again unless something gets out of sorts, e.g., down in South Texas and leaving your rifle and ammo in the truck. It gets VERY hot and can respond somewhat different. Again this is assuming you have weighed and culled your brass. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Houston I have a problem (22-250)
Top