Home made concentricity gauge

robbor

Well-Known Member
Joined
Jun 12, 2003
Messages
179
Well I have been kicking around building a concentricity gauge for a while as I have access to a bunch of dial indicators.
So I started drilling and laying it out today. I still need to go see about some SS roll pins for the stops and then decide where I will put the indicator shaft but I think its going to work well. Hey Victor your kids have ant more spare erector set parts /ubbthreads/images/graemlins/grin.gif?
aa2.jpg
 
[ QUOTE ]
I think its going to work well.

[/ QUOTE ]
Obviously, if it is homemade, it will work very well /ubbthreads/images/graemlins/grin.gif
 
[ QUOTE ]
[ QUOTE ]
I think its going to work well.

[/ QUOTE ]
Obviously, if it is homemade, it will work very well /ubbthreads/images/graemlins/grin.gif

[/ QUOTE ]

Well...at least in my mind!! /ubbthreads/images/graemlins/grin.gif But sometimes the wife does not agree!! /ubbthreads/images/graemlins/confused.gif
 
Warning! This thread is more than 18 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top