HELP ELDX rutumbo load data

Bruceanderson93

New Member
Joined
Aug 14, 2016
Messages
3
Hello I am new to reloading and have bought some 200gr hornady ELDX bullets. I am wanting to use rutumbo and can't seam to find any load data on the two together. Just wondering if anyone has anything on them
 
What cal are you loading for ?? Obvious a .308 diam cause that's all the ELDX comes in with a 200 grn pill. Need cal to get any other info for you.
 
93, per Hodgdon's data site starting 73gr and max 78gr for 200gr bullet in 300WM. Start low, work up. Good luck.
 
Cartridge : .300 Win. Mag.(SAAMI)
Bullet : .308, 200, Hornady ELD-X 3076
Useable Case Capaci: 77.693 grain H2O = 5.044 cm³
Cartridge O.A.L. L6: 3.340 inch = 84.84 mm
Barrel Length : 24.0 inch = 609.6 mm
Powder : Hodgdon Retumbo

Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-20.0 98 70.40 2522 2824 36845 11770 97.1 1.522
-18.0 100 72.16 2594 2988 39814 12065 98.1 1.466
-16.0 103 73.92 2666 3157 43050 12318 99.0 1.411
-14.0 105 75.68 2739 3331 46589 12527 99.5 1.359
-12.0 108 77.44 2811 3508 50458 12689 99.9 1.308
-10.0 110 79.20 2882 3688 54699 12800 100.0 1.260 ! Near Maximum !
-08.0 112 80.96 2953 3871 59360 12885 100.0 1.213 ! Near Maximum !
-06.0 115 82.72 3023 4057 64494 12964 100.0 1.168 !DANGEROUS LOAD-DO NOT USE!
-04.0 117 84.48 3092 4246 70159 13036 100.0 1.125 !DANGEROUS LOAD-DO NOT USE!
-02.0 120 86.24 3161 4438 76434 13100 100.0 1.083 !DANGEROUS LOAD-DO NOT USE!
+00.0 122 88.00 3230 4634 83402 13157 100.0 1.043 !DANGEROUS LOAD-DO NOT USE!
+02.0 125 89.76 3299 4834 91169 13205 100.0 1.004 !DANGEROUS LOAD-DO NOT USE!
+04.0 127 91.52 3368 5038 99861 13243 100.0 0.967 !DANGEROUS LOAD-DO NOT USE!
+06.0 130 93.28 3437 5247 109627 13271 100.0 0.931 !DANGEROUS LOAD-DO NOT USE!
+08.0 132 95.03 3507 5462 120657 13289 100.0 0.896 !DANGEROUS LOAD-DO NOT USE!
+10.0 134 96.79 3577 5682 133182 13294 100.0 0.862 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 122 88.00 3347 4975 104951 12608 100.0 0.962 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 122 88.00 3047 4124 65626 13946 99.8 1.153 !DANGEROUS LOAD-DO NOT USE!
 
Hello I am new to reloading and have bought some 200gr hornady ELDX bullets. I am wanting to use rutumbo and can't seam to find any load data on the two together. Just wondering if anyone has anything on them

There is a lot to what you are asking about.

The book data is on Hodgdon's web site is for Nosler AB and Partition. A significantly different shaped bullet.

What is your COAL?

This will help the most in getting things right.

Apparently I need an update for my QL as I don't have ELD-X
 
I think you will find that Retumbo may be too slow a powder to get decent velocity with.
H1000 is the slowest that I can think of that would be good, 7828, Rl22,25, & 26 would be better.

Cliff
 
Warning! This thread is more than 8 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top