Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
do you need to start over with load after neck turning?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DUSTY NOGGIN" data-source="post: 2071087" data-attributes="member: 89550"><p>measurememt doesnt matter to me, i aim for the same for my whole lot what ever the measuremnt ends up being .. </p><p>start at .015 pick 10 cases and slowly drop the cutter until the surface all the way around gets turned . if you get lower than .012 you probably need different brass</p></blockquote><p></p>
[QUOTE="DUSTY NOGGIN, post: 2071087, member: 89550"] measurememt doesnt matter to me, i aim for the same for my whole lot what ever the measuremnt ends up being .. start at .015 pick 10 cases and slowly drop the cutter until the surface all the way around gets turned . if you get lower than .012 you probably need different brass [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
do you need to start over with load after neck turning?
Top