Dies for the 338 Edge?

Totch94

Well-Known Member
Joined
Jan 20, 2007
Messages
114
I already have a set of .338 RUM dies and I was wondering if there was any reason I can't use a RUM seating and neck sizing die along with a 300 RUM body die to load the Edge? Am I missing anything here or will this set up work?

Thanks for your help!

Totch
 
Am I missing something?

I use a set of 338RUM dies to load for the Edge. The Rum sizing die is backed out of the press to accomidate the longer 300RUM case. SO if I now have an Edge case and run it back into the 300RUM sizing die will I not have returned it to 30 caliber?

Are you referrring to removal of the bushing in the 300 Rum prior to sizing the body of the Edge?

I have yet to use anything but my 338RUM sizing die on the Edge.

Neal
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top