custom dies


Well-Known Member
Jun 14, 2009
Who makes custom dies? Dont know if im going with the 7mm-338 lapua or 7mm-338 lapua imp. If I go with the the non-imp and use the redding type s dies to neck down what do I do about the seating die? Thanks

I've had a couple of sets done by them. I've sent the reamer print and they built from that. They will also work off of fired brass.
Neil Jones did my custom 338 Lapua AI dies. google neil jones dies

FL size die with shoulder bump bushings and micro seater

about 8-10 weeks, but worth every penny and the wait.

Warning! This thread is more than 14 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.