crown

dud

Well-Known Member
Joined
Feb 14, 2010
Messages
86
what kind of crown would you put on a 2506ai,10 twist,27 inch barrel?gun will be mostly used off bench for 100 gr and under bullets under 500 yd shots at groundhogs.does it matter
 
I machine the recessed target crown on everything I build. It seems to worh well with all the cal. I build. Hopes this helps.

Wayne
 
I like the 11 deg. target crown. It's easy to re-do if neccesary, and easy to see if it's damaged. Also very accurate for me.
 
I like the 11 deg. target crown. It's easy to re-do if neccesary, and easy to see if it's damaged. Also very accurate for me.

+1

I use different crowns for different purposes but mostly the 11 deg.

I don't find any accuracy advantage in any crown if it is done well, but a
big dissadvantage if it is not.

J E CUSTOM
 
thank you all.my last gun was an 11 degree and works well but wondered if the recessed was better.but i do see where the 11 would be easier to touch up.my smith will be back next week so i am excited to get this project going.
 
the 11 deg. target crown is not recessed, per sey, only the slight depression caused by the 11 deg. shape.

It is recessed per se. It is just not a stepped down 90 deg. crown. The 11 deg. crown is easier to maintain and affords plenty of protection. Generally it will be as deep as a 90 degree stepped crown, it just doesnt look that way.
 
With all the different guns I had built I wanted and love the 11 degree crown concentric to the bore within .0002" with a 60 degree chamfer has worked get on all of my toys.
 
what kind of crown would you put on a 2506ai,10 twist,27 inch barrel?gun will be mostly used off bench for 100 gr and under bullets under 500 yd shots at groundhogs.does it matter

One of these:

Recrowned2009-02-28RS.jpg


What is important about the crown is to have the plane of the crown at the muzzle perfectly orthogonal to the bore centerline at the muzzle, and have the edge of the exit hole perfectly symmetrical. For me that is easiest to do with a recessed target crown like this one. Crisp square edge, no bevel is easiest way for me to make sure all is symmetrical.

The only reason for the recess it to provide some measure of protection from damage. Other than that if it was a perfectly flat crown it would work fine.

The 11 degree crowns with a crisp edge work as well, they are just harder to make, so I do it this way.

Fitch

Fitch
 
Do you break the thin edge of the bore to keep it from burning off unevenly?

No, I don't. I cut it with a very sharp freshly honed HSS tool and oil. I leave it as cut. The edge is square and quite sharp. If the new camera adaptor I made for the borescope yesterday works as well as I hope it does, I'll see if I can post a picture of a this same crown a year, 500 rounds, and a number of cleanings later.

After a bronze brush has been run over the new crown it burnishes up sharp and square. It will stay that way unless abused.

Fitch
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top