Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Copper fouling location in barrel
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="L.Sherm" data-source="post: 2275889" data-attributes="member: 102083"><p>I dont know who you talked to about setting it back but they must have been talking about cutting the tenon off, all that has to be done is set it back 1 or 2 turns one in your case probably would be fine. 1 turn is about .062 on a rem which I'm sure would clean that throat up.</p><p>Its obviously from the reamer look at the original pics were the throat was cut, the bushing doesn't even touch that.</p></blockquote><p></p>
[QUOTE="L.Sherm, post: 2275889, member: 102083"] I dont know who you talked to about setting it back but they must have been talking about cutting the tenon off, all that has to be done is set it back 1 or 2 turns one in your case probably would be fine. 1 turn is about .062 on a rem which I'm sure would clean that throat up. Its obviously from the reamer look at the original pics were the throat was cut, the bushing doesn't even touch that. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Copper fouling location in barrel
Top