Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Concentricity:How much ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="padd54" data-source="post: 360112" data-attributes="member: 17530"><p>What tool are you all using to mearure the runout?</p><p> </p><p>I have the Sinclair tool and am still learning how to get consistant readings off the same case.</p><p>For my 338LM;</p><p>I measure after FL die before neck turning then after, this is when I segragate into three piles; .0005-.001, .0015-.002 and .0025-.003. Anything above .003 I will run through the FL die again to see if I can get it down to <.003.</p><p>I am using Redding Comp dies. Then I measure when the cartridge is complete and segregate again. I have had some of the them actually get better and move down to the next group.</p><p>I have never measured bullet runout, I can't seem to visualize how to hold the bullet in a consistant enough manner to get reliable readings. </p><p>I would appreciate guidance.</p><p> </p><p>Thanks,</p><p>Ray</p></blockquote><p></p>
[QUOTE="padd54, post: 360112, member: 17530"] What tool are you all using to mearure the runout? I have the Sinclair tool and am still learning how to get consistant readings off the same case. For my 338LM; I measure after FL die before neck turning then after, this is when I segragate into three piles; .0005-.001, .0015-.002 and .0025-.003. Anything above .003 I will run through the FL die again to see if I can get it down to <.003. I am using Redding Comp dies. Then I measure when the cartridge is complete and segregate again. I have had some of the them actually get better and move down to the next group. I have never measured bullet runout, I can't seem to visualize how to hold the bullet in a consistant enough manner to get reliable readings. I would appreciate guidance. Thanks, Ray [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Concentricity:How much ?
Top