Just checking to see if anybody uses one of these,
Do they work as claimed by Ch4D ?
http://www.ch4d.com/catalog/bullet/12000
my .375 wildcat was designed to seat the bullets .200" out past the bottom edge of the existing cannelure on the 300 gr Accubond bullet resulting in only the boat tail of the bullet seating past the neck maximizing case capacity,
BUT, now I am concerned about recoil and bullet movement in the cartridges in the detachable magazine,
any thoughts on this cannelure tool , or taper crimp, roll crimp etc. on the bullet ?
Do they work as claimed by Ch4D ?
http://www.ch4d.com/catalog/bullet/12000
my .375 wildcat was designed to seat the bullets .200" out past the bottom edge of the existing cannelure on the 300 gr Accubond bullet resulting in only the boat tail of the bullet seating past the neck maximizing case capacity,
BUT, now I am concerned about recoil and bullet movement in the cartridges in the detachable magazine,
any thoughts on this cannelure tool , or taper crimp, roll crimp etc. on the bullet ?
Last edited:
