Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case vibration
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Velvet" data-source="post: 1754952" data-attributes="member: 103348"><p>Hi guys</p><p>I performed some tests with satisfactory results.</p><p>With the joystick motor of a PS2, placed at one end of a reloading tray, the cases vibrate a lot, and the powder settles quite well.</p><p>As you can see, I had to put weight because if not, they vibrate a lot, with the risk that the powder will jump out of the case.</p><p>It occurs to me that placing 4 springs in the corners (as in the tumblers), I would avoid putting the weights. Placing the motor with the vertical axis, in the center and on the underside of the tray, would be an improvement as well.</p><p>A voltage regulator would be another improvement.</p><p>It helps a lot if we place a weight inside the mouth of the case, which compresses the powder as it vibrates. The necks were not rectified, that's why the bullet could go down freely, and there I discovered that it works.</p><p>Well, I hope it helped.</p><p>V</p></blockquote><p></p>
[QUOTE="Velvet, post: 1754952, member: 103348"] Hi guys I performed some tests with satisfactory results. With the joystick motor of a PS2, placed at one end of a reloading tray, the cases vibrate a lot, and the powder settles quite well. As you can see, I had to put weight because if not, they vibrate a lot, with the risk that the powder will jump out of the case. It occurs to me that placing 4 springs in the corners (as in the tumblers), I would avoid putting the weights. Placing the motor with the vertical axis, in the center and on the underside of the tray, would be an improvement as well. A voltage regulator would be another improvement. It helps a lot if we place a weight inside the mouth of the case, which compresses the powder as it vibrates. The necks were not rectified, that's why the bullet could go down freely, and there I discovered that it works. Well, I hope it helped. V [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case vibration
Top